8
Commissioning/start-up
NOTE
BioStyle 30 Thermo, 50 Thermo:
Fire hazard due to highly flammable material on hot surface.
f Only switch on the heater when it is completely submerged in water.
L If there is air in the telescopic intake, it may take up to 3 minutes for the pump to
deliver water.
x Switching on: Plug the power plug into the outlet.
– The unit switches on immediately.
– Lay the power supply cord so that a drip loop is formed and the lowest point is
below the socket. This prevents dripping water from entering the socket.
– Set the desired flow rate.
x Switching off: Pull the power plug from the outlet.
Form drip loop Adjust flow rate
BSE0024 BSE0013
To Next Page
Loading...
Need help?
General
