What to do if there is no water flow at the water outlets of Oase bitron 110c?
If there's no water flow at the water outlets of your Oase Water Pump, it could be due to a blocked flow nozzle. To fix this, disconnect the power supply and switch off the pump. Another possible cause is dirty water outlets, which would require cleaning the flow nozzle or the water outlets.
Why is my Oase Water Pump water cloudy?
Cloudy water can occur for several reasons. It may be due to a faulty UVC lamp connection, which requires checking the electrical connections. The cleaning rotor or quartz glass tube may be soiled, so cleaning is needed. An incorrect pump flow rate could also be the reason; refer to the installation guide for the correct flow rate. Other causes include brown suspended material or deposits, which means you should remove algae and leaves, and prevent dirt from entering. If the pond is extremely dirty, check the water values and change the water. If the UVC lamp has no capacity, check and replace it after 8,000 hours of use. Finally, an incorrect bypass adjustment can cause cloudiness; check the setting and note the pump capacity.
Specifies the restricted use of the Bitron unit for cleaning normal pond water.
Warns about dangers and voiding warranty if the unit is misused or used for unintended purposes.
Declares conformity with EC directives and lists harmonised standards applied to the unit.
Provides instructions on correct installation, including placement and distance from water.
Explains how to control water flow using the bypass system for optimal UVC radiation.
Details the procedure for replacing the UVC lamp after approximately 8,000 operating hours.
Covers automatic cleaning and manual cleaning of the quartz glass tube and inspection glass.
Provides guidance on winter storage and proper disposal of the unit and its components.
Lists common problems like cloudy water or no water flow, with their causes and remedies.
Highlights serious dangers from water/electricity combination and UVC radiation, advising electrician consultation.
Alerts to the influence of the magnetic field on pacemakers and advises against operating defective units.
Warns about dangerous UVC radiation and the need to check lamp seating and avoid direct exposure.
Covers protection from direct sunlight, frost removal, and safe disposal of the unit.
General| Power Consumption | 110 W |
|---|---|
| Protection class | IP 68 |
| Suitable for ponds up to max. | 11000 l |
| Voltage | 230 V |
| Frequency | 50 Hz |
To Next Page