6
English
Do’s
— Make sure that the unit is installed in accordance with all
National and Electrical Codes.
— Make sure to install the Filtoclear at least 6,5 feet from the
edge of the pond.
— Make sure to keep the outlet system free of dirt and debris.
— Make sure to unplug the unit before servicing the unit.
— Make sure to keep the plugs and connections dry at all times.
— Make sure to return the unit to an authorized service dealer
for any repairs.
Don’ts
— Do not exceed the “Maximum Operating Pressure” of 2,9 psi
( 0,2 bar).
— Do not carry or pull the unit by the power cord.
— Do not tamper with or operate unit without the proper ground-
ing plug.
— Do not operate the unit if the power cord appears to be defective.
— Do not operate the lamp outside of the housing.
— Do not operate the unit without water flowing through the unit.
— Do not expose eyes or skin to the lamp’s rays.
— Do not attempt any repairs on this unit.
— Do not open the casing of the Bitron or its accessories un-
less expressly directed to do so in the instructions
- Before starting up the Filtoclear, check that the connected
hoses, the sealing cap and the tension ring with safety latch
are sitting correctly.
- Never pump any liquids other than water!
- When frost is expected, you must remove the Filtoclear with
integrated UVC.
- Install the Filtoclear where it will not be exposed to direct
sunlight.
- Please observe the local noise protection regulations.
To Next Page
Loading...
Need help?
General
