Oase Filtoclear 15.000

Questions and Answers

C
Christopher HarrisAug 8, 2025
Why is the water not clear in my Oase Water Filtration System?
- C
  Cory VasquezAug 9, 2025
  If the water in your Oase Water Filtration System isn't clearing, it might be due to several reasons. If the unit is new, allow several weeks for the biological cleaning effect to fully establish. Ensure the pump capacity is adequate and readjust if necessary. Clear the pond of excessive algae and leaves, and consider a partial water change if the water is extremely soiled. Check that the fish population isn't too high; aim for approximately 60 cm of fish length per 1 m3 of pond water. Also, clean the foam filters and the quartz glass tube to ensure proper function.
W
William DuncanAug 17, 2025
What to do if the UVC lamp display is not lit on my Oase Water Filtration System?
- M
  Matthew GatesAug 17, 2025
  If the UVC lamp display on your Oase Water Filtration System is not lit, there could be a few reasons. First, ensure that the power supply of the Filtoclear-UVC is properly connected. If it is, the UVC lamp might be defective and need replacement. Also, check the electrical connection for any defects. If the lamp has been in use for approximately 8,000 operating hours, it may have reached the end of its capacity and needs replacing. Make sure that the function switch is turned to 'Filter' and not 'Cleaning'. Finally, if the Filtoclear-UVC overheated, the UVC will automatically switch on when cooled down.
J
Jennifer TrujilloAug 25, 2025
How to fix no water coming from the outlet of Oase Water Filtration Systems?
- P
  pattontylerAug 25, 2025
  If no water is coming from the outlet of your Oase Water Filtration System, start by checking if the pump power supply is connected. If the pump is connected, the outlet may be blocked and needs cleaning.
B
bandersonAug 31, 2025
What to do if no water is coming from the outlet of Oase Water Filtration Systems?
- I
  Ian FisherAug 31, 2025
  If no water is coming from the outlet of your Oase Water Filtration System, verify that the pump power supply is connected. Also, check the outlet for any blockages and clean it if necessary.