6
- English -
10. Connect the pump adapter to the pump, then connect the
tubing (Part G) to the adapter; use hose clamp to hold it tight.
NOTE: Pump, adapter and hose clamp are NOT INCLUDED.
11. Put the pump inside skimmer, then connect the other side of
tubing to the adapter (Part D1).
○ Use a hose clamp to hold it tight.
○ Route the cord through the hole in the back top corner of
the skimmer.
NOTE: Hose clamp is NOT INCLUDED.
12. Put the debris basket inside the skimmer, then place the cover
on the skimmer.
○ Pivot the door up and into the skimmer.
13. Connect tubing to the outlet of the skimmer with adapter (Part
D2), use a hose clamp to hold it tight.
○ The tubing can then either direct back into your pond or, for
best results, connect to a waterfall spillway.
○ Carefully cover the skimmer and tubing with natural material
for a professional look.
NOTE: Tubing, hose clamp and spillway are NOT INCLUDED.
10.
11.
12.
13.
Adapter
Tubing
Tubing
Hose clamp
Adapter
Pump
To Next Page
Loading...
Need help?
General
