To Next PageTo Next PageHow to troubleshoot Oase Nautilus 50 Water Pump that does not run?
If your Oase Water Pump isn't running, first check the mains voltage to ensure it's properly connected. If the voltage is fine, the rotor might be blocked. In this case, clean the pump to remove any obstructions.
What to do if Oase Nautilus 50 Water Pump switches off after a short period of operation?
If your Oase Water Pump switches off after a short period, it might be due to a clogged filter. Clean the filter to resolve this. Another possible cause is that the water temperature is too high. Ensure that the water temperature does not exceed +35°C.
What to do if the temperature is below zero for Oase Nautilus 50 Water Pump?
To prevent damage, the Oase Water Pump should be removed when temperatures drop below zero.
Why is the fountain height insufficient or inconsistent in my Oase Nautilus 50?
If the fountain height of your Oase Water Pump is insufficient or inconsistent, there are several potential causes. Start by checking if the main flow regulator is closed too far and adjust it accordingly. Also, inspect the nozzle, filter/screen, and hose for any blockages and clean them if necessary. Ensure the hose isn't kinked, and if it is, replace it. If the hose is excessively long, consider reducing its length to minimize friction loss. Lastly, a worn rotor can also cause this issue, so consider replacing it.
General| Brand | Oase |
|---|---|
| Model | Nautilus 50 |
| Category | Water Pump |
| Language | English |
Details on starting up the pump and setting up the fountain.
Instructions for cleaning and maintaining the pump unit.
Guidance on storing the unit during winter or frost periods.
Troubleshooting guide for common issues and their solutions.
Guidance on reading and understanding the operating manual.
Specifies the intended purpose and application of the Nautilus pump.
Warns about risks and warranty voidance for misuse.
Manufacturer's declaration of conformity with EC directives.
Instructions for fitting the nozzle tube components.
Guidance on positioning the unit correctly in the pond.
Information on how the unit automatically switches on.
Instructions for removing the unit for cleaning.
Procedure for replacing the sealing ring in the nozzle tube.
