- EN -
19
Installation and connection
Attention! Dangerous electrical voltage.
Possible consequences: Death or severe injuries caused by electric shock from electrical units operated in
or near water.
Protective measures for accessible ponds:
Only use electrical units or installations with a rated voltage of U
AC
12 V or U
DC
30 V in the water.
Electrical installations with a rated voltage of U
AC
> 12 V or U
DC
> 30 V must be located at a distance of
at least 2 m from the water.
Protective measures for non-accessible ponds:
Electrical installations with a rated voltage of U
AC
> 12 V or U
DC
> 30 V must be located at a distance of at
least 2 m from the water.
Set-up the unit
Do not suspend the pump from the suction socket or pressure socket.
– The pump housing may be damaged.
Submerged installation of the pump
B
Never operate the pump in a swimming pond.
Only operate the pump with the filter basket fitted.
Only operate the pump when it is below the water surface level.
Ensure that the pump is in a secure and stable position.
The position of the pump outlet can be changed. The pump casing has to be turned to achieve a different position.
(→ Turning the pump casing to achieve a different position )
How to proceed:
D
1. Place the pump with stand in a horizontal position on a suitable base and bolt down.
– Ensure that the pump is fully submerged in the water.
2. Screw the nozzle onto the pump outlet.
Install the unit at a dry place
C
Swimming pond or pool that may be accessed by people.
– Install the unit at least 2 m away from the water.
Do not expose the unit to direct sunlight.
Ensure that the pump is in a secure and stable position.
The position of the pump outlet can be changed. The pump casing has to be turned to achieve a different position.
(→ Turning the pump casing to achieve a different position )
How to proceed:
E
1. Remove the screws for fastening the filter basket and remove the filter basket.
2. Place the pump with stand in a horizontal position on a suitable base and bolt down.
3. Connect the suction line to the inlet.
4. Connect the pressure line to the outlet.
To Next Page
Loading...
Need help?
General
