Obel Mito Base - Troubleshooting

16
INSTALLAZIONE, USO E MANUTENZIONE
INSTALLATION USE AND MAINTENANCE
unplugged.
• Always replace both burrs.
Burrs replacement :
• Set in the hopper closure
• Activate the grinder until no more powder will be dispensed
• Turn off and unplug the grinder
• Remove the hopper by unscrewing it
• Unscrew the lock screw from the grinding adjustment gear.
• Press down the docking rod with one hand and with the other unscrew the
burrs housing gear by turning it anti-clockwise
• Unscrew the 3 burrs docking screws then remove the burrs; make sure to
remove any trace of coffee powder from the burrs housing
• Place and lock a new set of burrs in the housing
• Screw the adjustment gear on the grinder’s body until the burrs touch
• Unscrew the adjustment gear by 5 – 10 steps
• Insert and lock the beans hopper
• Plug in the grinder and turn it on
• Open the hopper closure and set up the grinding grade while the grinder is
running
Problem
Cause
Solution
The coffee grinder does
not turn on
Plug not in the socket
Faulty electronic control
unit
1-Check that the plug is inserted in
the power socket. Inspect the
electric cable.
2-Contact the technical assistance
service
The motor does not run
1-Foreign body between
the burrs
2-Overheating
3-Broken capacitor
1 -Unplug the coffee grinder and
unscrew the adjusting screw
toemove the foreign body.
2 - Wait for the grinder to cool down.
3 -Contact the tecnical assistance
service
Coffee powder mixed in
with larger fragments
Worn burrs
Not perfectly flat burrs
Replace the burrs
The motor does not run
and the grinder is
beeping
(Only Mito ATR Perf)
The protection timer has
stopped the grinder
(Only Mito ATR Perf)
Turn off the grinder with the main
switch, then restart the grinder
turning on the main switch
(Only Mito ATR Perf)
TROUBLESHOOTING