Oberheim XK - CALIBRATING; Continuous Controller (slider); Levers

CALIBRATING
Continuous Controller (slider)
This calibration is performed at the factory and should be performed only if the user feels it is not
correct. To calibrate the slider, turn the power OFF. Postion the slider full left and while holding the
Chord Switch apply power. This calibrates the slider.
1) .. 4 „ MOVEFULLLEFT
continuous controller
CHORD
2) O
Levers
The levers are calibrated every time the Xk is powered up. The only thing to remember is not to
move the levers when applying power.
27