Objecto F5 - Setup Procedures; Unit Placement and Power Connection

8
English
The height is about 22” when the middle tube is not used.
Put the base on a stable position. 1
Press the lock button to remove the unit top and middle tube. *
Rear
1
2
Attention
There should be no gaps between the connected parts.
If the installation is not connected properly, the fan may shake or dislodge.
Put the main unit on a stable level place2.
Hold the handle to pick up and move the main unit.•
Use a dedicated AC adapter3.
DC jack
DC plug
Cable hook
DC cord
1
2
Please insert the DC plug of the AC adapter is into the DC jack on the back of 1
the base.
In order to avoid tripping over the cord, hook it to the base.
2
192001aF5FKLS-302DEng.indd8192001aF5FKLS-302DEng.indd8 2019/04/1018:36:362019/04/1018:36:36