OCEAN DRIVE E8 PLUS - Lock Function

13. “LOCK”FUNCTION
- The e-scooter is equipped with an electronic lock, but it is deactivated by default.
To activate the electronic lock, the entire procedure below must be completed
within 30 seconds of turning on. Otherwise, it will be necessary to restart the
e-scooter to begin again.
- To activate the “LOCK” function:
a• Turn on the e-scooter by pressing the ON/OFF key (25) for about 3 seconds, you will hear a
beep and the display will light up. The e-scooter is on;
b• To activate the lock code, press the the ON/OFF key (25) quickly 7 times.
The default code is 00. To enter the digits, use the brake lever (11) to scroll through the left
digit and the throttle lever (12) to scroll through the right digit;
c• Validate by pressing the ON/OFF key (25) twice.
- To set your custom code:
a• Unlock the e-scooter (see procedure above);
b• Press the ON/OFF key (25) button 7 times;
c• Enter the active code (for the rst change, the active code is 00);
d• To enter the new code, use the brake lever (11) to scroll through the left digit and the throttle
lever (12) to scroll through the right digit;
e• Validate by pressing the ON/OFF key (25) twice;
f• A second entry will be requested to set a new code, once chosen, validate by pressing the
ON/OFF key (25) twice.
106
EN