2 Quick start guide
To start using your SoundTrap you’ll need to install the SoundTrap Host software.
2.1 Install the SoundTrap host on your PC
• Pre-installation Notes:
o The SoundTrap host software supports Windows 7 and 8 (32 or 64 bit versions).
o Do not connect the SoundTrap to your computer until you have completed the
SoundTrap host software installation.
o The installation will be smoother if you’re logged into windows as an administrator.
• Visit www.OceanInstruments.co.nz/downloads/ to download the software.
• Download and run the installer.
• Once the install completes, run the SoundTrap Host application.
2.2 Connect SoundTrap to your PC
• Connect the SoundTrap using the USB cable provided.
• The drivers will take a couple of minutes to install. Once complete you should see your
SoundTrap appear in the ‘Device List’ on the left, as shown in figure 1.
• Select your SoundTrap by clicking its label on the left.
To Next Page
Loading...