Ocean Instruments SoundTrap ST300 Series - Begin recording using the IR Remote Control

2.5 Begin recording using the IR Remote Control
You may use the remote control to start recording.
• Press ‘START’ to start recording.
• Press ‘STOP’ to stop recording.
• If you have set a recording to start recording at a
later time, the recorder will blink red to indicate it
is ‘armed’ and waiting.
• The ‘armed’ state is cancelled by pressing Stop key.
• Re-enable the armed state by pressing the ARM
button.
• You can verify recording has started by checking
for slow blinking of the status (green) indicator.
• Note that the remote is splash proof and designed to tolerate wet hands. Don’t attempt
to use it underwater – you’ll be disappointed.