2.6 Check SoundTrap Status
Note the ‘Status’ panel on the right (Figure 4). Carefully review the state of memory and
batteries in the right-hand pane, checking that all batteries show 100% charge and all
memory show 0% used.
Figure 4 – Deploy Control
2.7 Configure the deployment
• Select the ‘Deploy’ tab as shown in figure 4.
• Configure the deployment parameters as follows:
o The ‘Recording Starts’ section determines when recording will begin. Recording can
begin immediately on disconnection of the USB cable, at a pre-determined date and
time, or manually using the IR remote control. Note that the remote can always be
used to override the other options.
To Next Page
Loading...