EPIRB1 Pro USER MANUAL
12 912S-03403-02.00 27/07/2020
4. LOADING THE EPIRB1 PRO
! When replacing the EPIRB1 Pro in the Float Free Housing please ensure that the
unit is clean and dry. The area around the activation controls and the lanyard
should be free from water and dirt to ensure reliable operation.
The EPIRB1 Pro is held in place inside the Float Free Housing by the Hydrostatic Release
Unit (HRU) which locks into position using a spring.
Following installation (or after maintenance, testing, etc.) it is necessary to replace the
EPIRB1 Pro into the Float Free Housing.
1. Pull back the HRU
2. Load the EPIRB1 Pro, controls
facing up, into the location seat,
ensuring to carefully fold the
antenna back behind the EPIRB1
Pro.
3. Gently lower the HRU back into
the locked position - this holds
the EPIRB1 Pro securely in place.
4. Place the housing cover over
the back, by placing the locating
holes (on the side of the housing)
over the clips.
To Next Page
Loading...
Need help?
General
