4 Safety Instructions
6 / 36 Instruction Manual BIOM® 5 (G/55400/1218/en)
Operation and maintenance information
Before initial operation: Let OCULUS or an authorized dealer train
you in the operation of the BIOM® 5.
Never operate a damaged BIOM® 5.
Only operate the BIOM® 5 using original accessory parts supplied by
us, and when the device is in technically perfect working order.
Only operate the equipment after your have read and understood the
instruction manual.
The BIOM® 5 and all sterilisable BIOM® 5 components must be
sterilised:
Before the first use
After every use
It is imperative that you heed the cleaning, disinfection and
sterilisation instructions given in the conditioning manual.
4.2.1 Instructions for Use
Attention
Risk of eye damage if the working distance between the BIOM® 5 and the
patient changes
When the BIOM® 5 is swung into the working position (into the beam pa-
th), the following instructions must be followed:
Do not use the coarse adjustment knob at the microscope stand to
adjust the height.
Do not adjust the height of the stand arm, either by motor or
manually, over the surgical area.
Do not change the patient’s position by adjusting the height of the
operating table.
Pay attention to the focussing instructions, sec. 9.7, page 19.
More information can be found in the Application tips: BIOM® 5 and
can be downloaded from the OCULUS website.
Troubleshooting
If a fault occurs that you cannot rectify with the help of the
troubleshooting table (page 23), the unit must not be used! Clearly
mark the unit as non-operational and get in touch with our service
personnel.
Instructions for disassembly and disposal
Dispose of the equipment in compliance with the corresponding
legal requirements. Comply with the hygiene and disposal
regulations of the hospital or clinic.
To Next Page
Loading...
Need help?
General
