To add oil, remove the dipstick. Place a
funnel into the dipstick tube to avoid
spillage.
Add a small amount of recommended oil
and recheck oil level.
Repeat the above procedures until oil level
reaches the dipstick's upper mark.
NOTE: Do not overfill. Wipe off any spillage.
Properly tighten dipstick.
Close cargo box.
Changing the Engine Oil
Oil change and oil filter replacement should
be done with a warm engine.
CAUTION The engine oil can be very hot.
Wait until engine oil is warm.
Ensure vehicle is on a level surface.
Remove dipstick.
Place a drain pan under the engine drain
plug area.
Unscrew magnetic drain plug and discard
the gasket ring.
Clean the drain plug area. Unscrew
magnetic drain plug and discard the gasket
ring.
Wait a while to allow oil flow out of
gearbox.
1.Magnetic drain plug
2.Gasket ring
Allow oil to drain completely from the
crankcase. Clean the magnetic drain plug
from metal shavings and residue. Presence
of debris gives an indication of internal
engine damage.
Install a NEW gasket ring on the magnetic
drain plug.
NOTICE Never use the gasket ring a second
time. Always replace by a NEW one.
Tighten magnetic drain plug to the
specification.
To Next Page
Loading...
