6.ELECTRICAL SYSTEM
6-1
Overhauling information································ 6-1
Electrical ..................................................................6-2
BATTERY...................................................................6-6
STARTING SYSTEM............................................. 6-7
PROCEDURES..........................................................6-8
EFI System........................................................... 6-11
Overhauling information
Warning
‹ Bulb will be very hot after turning on headlamp. Please do not touch it immediately after
its off. In operation, bulb needs to be cooled.
‹In warning inspection of water temperature, fire or high temperature liquid may be needed.
Keep it far away from in flammables and do not to be burnt.
‹ The temperature will be very high in turning of headlamp. For replacement, grease dirt will
be splashed to glass in case of operation with bare hands or wearing dirty gloves. As a result,
hot spots and glass deformation may be caused with damage to bulb as well.
‹ Pay attention to the following in replacing bulb:
-- Do not replace bulb when it is on. Turn off ignition switch and replace it after cooling
bulb.
-- In order to avoid splashing grease to glass, wear clean gloves in replacing bulb.
-- Use cloth with alcohol or banana water to clean glass to prevent any grease sticking to
glass.
‹ Check battery to confirm whether it is normal.
‹ Regularly check switch and do not dismantle it from vehicle in inspection.
To Next Page
Loading...
