Activating a New Battery
Refer to the instructions provided with the
battery.
Charging a Battery
NOTICE: If battery becomes hot, stop
charging and allow it to cool before
continuing.
NOTE: If battery pressure increases due to
overcharging, the valve opens to release
excess pressure, preventing battery
damage.
An automatic charger is a fast and
convenient way for error-proof charging.
Always follow the battery manufacturer's
charging instructions.
When using a constant current charger,
charge battery according to the chart
below.
Battery Voltage Below 12.8 V and Above
11.5V
Installing the Battery
NOTICE: Always connect RED (+) cable
first then BLACK (-) cable.
STARTING SYSTEM
GENERAL
SYSTEM DESCRIPTION
The starting system is composed of an
electric starter supplied in current by the
battery through a solenoid.
The starter solenoid receives a 12 volt input
from the ignition switch and the ground
signal is provided by the Gear controller.
– Transmission in Park or Neutral position
and/or brake pedal held.
– Ignition switch turns to the start position
and hold until the engine starts.
To Next Page
Loading...
