OEC 9800C-Arm - Page 112

Interlocks
Functional Tests
Perform the following tests to verify that the system is operating satisfactorily.
(Refer to the 9800 C-Arm Sub-system chapter of this manual for Functional Tests.)
1. System Boot
2. Make a fluoroscopic exposure
3. Press one of the Fast Stop buttons on the C-arm Control Panel. The message “FAST STOP ACTIVATED. POWER
DOWN. WAIT 5 SECONDS” should be displayed. X-ray generation should be disabled.
4
Service Periodic Maintenance
Contents
Schematics Illustrated Parts Installation