To Next PageTo Next Page
Need help?Do you have a question about the OEC 9600 and is the answer not in the manual?
General| Type | Mobile C-arm |
|---|---|
| X-ray Tube | Rotating anode |
| Workstation | Integrated |
| Image Intensifier | 9" |
| Fluoroscopy Mode | Pulsed |
| kV Range | 40-120 kV |
| Focal Spot Size | 0.3 mm and 0.6 mm |
| Field of View | 9 inch or 12 inch |
Critical safety precautions and warnings for operating the system.
Steps to safely disconnect power and remove covers for maintenance access.
Inspection of mechanical components like brakes, locks, and steering.
Testing of C-Arm movements like Wig Wag, Flip Flop, Orbital, and Cross-Arm.
Testing ground continuity of the system power cord and interconnect cable.
Testing vertical lift and L-Arm rotation, including limit switch operation.
Testing collimator iris, shutter, and rotation controls.
Verifying the fluoro timer functions, alarm, and reset.
Testing the function of the two FAST STOP emergency switches.
Checking the operation of the footswitch controls for various modes.
Verifying the operation of the handswitch controls for various modes.
Running diagnostic tests for panel LEDs, keys, and kV/mA.
Verifying battery pack performance and charger PCB.
Checking DC power supplies on the Image Processing PCB.
Measuring radiation dose rate at the entrance point of patient anatomy.
Recording actual dose rate, maximum kV, and BOOST mode.
Testing the accuracy of the system's kVp.
Verifying image resolution meets specified line pairs/millimeter.
Testing kVp tracking with copper filters added in the beam path.
Performing various system function tests including camera alignment.
Performing exposures and measurements for beam alignment verification.
