9600 Periodic Maintenance Procedure 00-880606-02
Page 39
TYPE
Record the equipment type on the PM Inspection From.
MODEL
Record the equipment model numbers on the PM Inspection From.
SERIAL NUMBER
Record the equipment serial numbers on the PM Inspection From.
CALIBRATION DUE DATE
Record the equipment calibration due date on the PM Inspection From.
TOOLS
In addition to common hand tools, the following tools are required:
• Torx Screwdriver Set
• Spline Driver, .048, P/N 00-900920-01
TEST EQUIPMENT
• Oscilloscope Tektronix 2236 or equivalent
• Digital Volt-Ohm-Meter
• Dosimeter (Keithley Model 35050, PMX II non-invasive meter or equivalent)
• Model 96030 ion chamber or equivalent
• kVp meter
• Bore Sight Tool, P/N 00-877589
• Resolution Tool
• Lead Apron
• 1 mm Copper Filter (3 each req’d), P/N 00-877682-01
• 9600 Boot and Diagnostic Disk (software), P/N 00-877444-01
• 9″ Beam Alignment Tool, P/N 00-878105-01
• 12″ Beam Alignment Tool, P/N 00-878867-01
To Next Page
Loading...
