Stator Power and Control
5. After about 10 minutes of idle time, the system enters “sleep” mode, and the stator drive is turned off. When reactivated,
Steps a and b above are repeated before X-Rays can be made. You should be able to hear the anode whirring, and the
successions of relay clicks, indicating that the system came out of sleep mode.
Filament Selection
(This information is part of the mA Generation chapter)
Functional Tests
To functionally test the Stator Power and Control function, perform the following applicable tests (see C-Arm Subsystem chapter
of this manual).
• Boot Test
• Fluoro Mode Performance Check
• Film Mode Performance Check
4
Service
Periodic Maintenance
Contents
Schematics
Illustrated Parts
Installation
To Next Page
