Calibration
Overview
The Generator Calibration and Beam and Camera alignment procedures described next prepare the system for operation, and
should be performed each time you replace a major system component. When possible, run these tests in the same sequence
that they appear in this section.
Required Tools and Equipment
Extender PCB (00-879248)
Beam Alignment Fixture Tool (BAFT) (9-inch BAFT is 00-878105-01; 12-inch BAFT is 00-878867)
Boresite Alignment Tool (00-879599)
Converging line pair tool (00-900860)
Bristol six-flute spline tool, .048 (00-900920)
Wisconsin mesh tool (00-900040)
Serial cable (00-901559)
Three 1 mm sheets of copper (00-877682)
Remote Utility Tool (RUT) software (00-881671) (pre-OPIS)
Remote UtilitySuite software (00-884049)
AT keyboard (00-900598)
Nine-inch VGA monitor (00-901163)
Dosimeter with 15cc and 150cc Ion Chambers
DAP Paddle Holder (00-882027)
Tektronix Photometer
Fostec Calibrated Light Source
Fostec Light Source Control PCB (00-882068)
3
Service
Periodic Maintenance
Contents
Schematics
Illustrated Parts
Installation
To Next Page
Loading...
