Replacement
Power Signal Interface PCB
Many of the field replaceable fuses associated with C-Arm circuitry reside on the Power Signal Interface PCB. Refer to the
following illustration and table for details.
WARNING: Don't replace any fuse on the Power Signal Interface PCB without first powering down
the system. Failure to observe this precaution may result in potentially fatal electric
shock or burns, and may also cause equipment damage.
Note: 115 VAC power from Workstation Interconnect Cable plug P1 enters Power/Signal Interface PCB on P5.
27
Service
Periodic Maintenance
Contents
Schematics
Illustrated Parts
Installation
To Next Page
Loading...
