Replacement
Power Supply PS3
PS3 mounts on the left-hand side of the C-Arm chassis under the Left Side Cover and Component Tray Cover. It has no external
controls and only three connectors.
Follow these steps to replace PS3:
WARNING: Dangerous AC line voltage is present on PS3’s POWER connector.
1. Turn off Workstation and disconnect its AC power plug from AC outlet.
2. Remove Left Side Cover.
3. Remove Component Tray Cover.
4. Remove and retain four torx screws and washers that secure PS3 to C-Arm chassis.
5. Disconnect POWER, CONTROL, and OUTPUT connectors from PS3.
6. Lift PS3 out of C-Arm.
7. Inspect replacement power supply for any obvious damage or missing components.
8. Connect POWER, CONTROL, and OUTPUT connectors to replacement power supply.
9. Mount replacement power supply assembly to C-Arm chassis and secure mounting hardware.
10. Connect Workstation’s AC power plug to AC outlet.
11. Check system for proper operation.
12. Reinstall Component Tray Cover.
13. Reinstall Left Side Cover.
82
Service
Periodic Maintenance
Contents
Schematics
Illustrated Parts
Installation
To Next Page
Loading...
