Replacement
X-ray Controller PCB
The X-ray Controller PCB mounts in the Electronic Card Rack as shown next.
WARNING: Dangerous voltages are present when covers are removed from the C-Arm.
Follow these steps to replace the X-ray Controller PCB:
1. Turn off Workstation and remove its power plug from facility's AC outlet.
2. Remove the Rear Cover and disconnect the steering linkage.
3. Remove the Electronic Card Rack Cover.
4. Remove suspect X-ray Controller PCB.
5. Install replacement X-ray Controller PCB.
6. Install Electronic Card Rack Cover.
7. Power up system and check for proper operation.
8. Install covers and reconnect steering linkage.
87
Service
Periodic Maintenance
Contents
Schematics
Illustrated Parts
Installation
To Next Page
Loading...
