Replacement
Mechanical Assemblies
The following paragraphs describe field replacement of certain C-Arm mechanical assemblies.
Cable Pushers
The following illustration shows one rear caster Cable Pusher:
Follow these steps to remove a Cable Pusher or Wheel:
1. Remove two screws from the End Cap cover and remove the End Cap.
2. Remove the decals from each side of the Wheel assembly.
3. Remove the hole plug (right/top) from each side of the Wheel assembly and retain the plugs.
4. Remove the Allen Screw from each hole plug.
5. Remove four screws (two each side) from the Wheel Covers (located where the decals were).
6. Remove the Wheel Covers from each side of the Wheel.
7. Jack the Wheel Axle up approximately 2 - 2.5 inches.
8. Remove four Torx Screws (two each side).
9. Remove the Cable Pusher Assembly and then remove the Cable Pusher Assemblies Feet by removing 2 screws from each
side.
10. To remove the wheel from the Rear Wheel Assembly, remove the 1/2-inch bolt.
94
Service
Periodic Maintenance
Contents
Schematics
Illustrated Parts
Installation
To Next Page
Loading...
