User and settings manual
ENG
9
Selected hydraulic scheme can be later changed with service parameter S1.1.
Controller RESET!
Disconnect the controller from the power supply. Press and hold the button
and switch on power supply. The controller resets and goes to initial
setup.
CAUTION!
By selecting ‘reset’ all previous controller settings are erased.
Next, you select a hydraulic scheme for the controller
function. Move between schemes by means of buttons
and .
Confirm the selected scheme by pressing the
button.
STEP 2
After you selected the scheme, the controller requires
confirmation of the selection by pressing the
button.
If you accidentally selected the wrong scheme, go back
to reset the scheme by pressing button .
To Next Page
Loading...
Need help?
General
