7
Operating Instructions and Parts Manual 24665
11/18
2018 OEMTOOLS
™
HEAT GUN
DO NOT use solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use.
Use a clean cloth dampened with a mild detergent to
remove dirt, dust, oil, grease, etc.
WARNING:
DO NOT at any time allow brake fluids, gasoline,
petroleum-based products, penetrating oils, etc. to come
in contact with plastic parts. They contain chemicals that
can damage, weaken or destroy plastic.
LUBRICATION
All of the bearings in this Heat Gun are lubricated with
a sufficient amount of high-grade lubricant for the life of
the unit under normal conditions. Therefore, no further
lubrication is required.
This symbol designates that this tool has been
certified by ETL Testing Laboratories, Inc. to
meet Std. 499. Certified to CAN/CSA Std.
C22.2 No. 122
PARTS DIAGRAM – MODEL 54-6502-2
Item# Description Qty.
1 Cord 1
2 Cord Guard 1
3 Connection Pole 1
4 Cord Clamp 1
5 Screw ST3.9 x 14 2
6 Switch 1
7 Left Housing 1
8 Back Housing 1
9 Peg Plank 1
10 Screw ST2.9 x 12 5
11 Motor 1
12 Motor Board 1
13 Screw M2.5 x 5 2
14 Fan 1
15 Screw ST2.9 x 9 3
16 Air Deflector 1
17 Chinaware 1
18 Wind Duct 1
19 Orientation Ring 1
20 Right Housing 1
21 Screw ST3.9 x 19 5
22 Guard 1
23 Hang Loop 1
NOTE: Not all components of the Heat Gun are
replacement items but are illustrated as a convenient
reference for location and position in the assembly
sequence.
PARTS LISTPARTS DIAGRAM
To Next Page
Loading...
