OEM Tools 25712 - Operating Instructions and Cautions; Operating Instructions; Battery and Usage Cautions; Maintenance and Warranty Information

3
Operating Instructions and Parts Manual 25712
11/15
2015 OEMTOOLS
BATTERY-OPERATED
LIQUID TRANSFER PUMP
CAUTION
This equipment is intended only for professional use by personnel trained
in performing the service functions for which it is has been designed.
This equipment is designed for servicing a variety of vehicles in a safe,
convenient manner. However, differences in vehicle makes and models
may make it impossible to use this equipment as it is intended.
DO NOT attempt to force the use of this equipment on an application for
which it is not designed to perform.The procedures documented in this
manual are to serve as guidelines for the use of this equipment.
In addition to these guidelines, always follow the manufacturer’s
recommended procedures when servicing each unique vehicle.
OPERATING INSTRUCTIONS:
1. Insert 2 “D” size batteries (not included) as shown in Diagram A.
2. Immerse the suction end of the pump into the liquid.
3. Insert the discharge hose into a container to receive the liquid.
4. Turn the switch to the On position to begin pumping. Be careful not
to fill the container too much. Shown in Diagram B.
BATTERY CAUTIONS:
1. Non-rechargeable batteries are not to be recharged.
2. All batteries used must be of the same brand and type.
3. Do not mix alkaline, standard (carbon-zinc) or rechargeable
(nickel-cadmium) batteries.
4. Do not mix old and new batteries.
5. Remove old batteries.
6. Remove batteries when not in use.
CAUTIONS:
1. Do not run dry. Only switch the pump on after submerging the
suction end of the pump in liquid.
2. Do not turn the pump upside down after use.
3. Do not place the pumping container higher than the pump’s
batteries housing.
4. Rinse with water after use.
5. Store or use when the unit is thoroughly dry.
NOTE: In case any liquid backs up in the hose, it will drain from the
bottom of the “Overflow Outlet”. Keep hands away from these points.
Do not use this pump near an open flame while pumping gasoline.
MAINTENANCE:
1. Always store the Battery-Operated Liquid Transfer Pump in a well-
protected area where it will not be exposed to inclement weather,
corrosive vapors, abrasive dust or any other harmful elements.
2. Keep the Battery-Operated Liquid Transfer Pump clean for better
and safer performance.
OPERATING INSTRUCTIONS:
1. Insert 2 “D” size batteries (not included) as shown in Diagram A.
As shown in Diagram B:
1. Immerse the suction end of the pump into the liquid.
2. Insert the discharge hose into a container to receive the liquid.
3. Turn the switch to the on position to begin pumping. Be careful not to fill the container
toomuch.
BATTERY CAUTIONS:
1. Non-rechargeable batteries are not to be recharged.
2. All batteries used must be of the same brand and type
3. Do not mix alkaline, standard (carbon-zinc) or rechargeable (nickel-cadmium)
batteries.
4. Do not mix old and new batteries.
5. Remove old batteries.
6. Remove batteries when not in use.
CAUTIONS:
1. Do not run dry. Only switch the pump on after submerging the suction end of the
pump in liquid.
NOTE:
In case any liquid backs up in the hose,it will drain from the bottom
of the "Overow Outlet".Keep hands away from these points.
Do not use this pump near an open ame while pumping gasoline.
2. Do not turn the pump upside down after use.
3. Do not place the pumping container higher than the pump’s batteries housing.
4. Rinse with water after use.
5. Store or use when the unit is thoroughly dry.
ON
OFF
LIQUID
DISCHARGE HOSE
SUCTION END
OPERATING INSTRUCTIONS:
1. Insert 2 “D” size batteries (not included) as shown in Diagram A.
As shown in Diagram B:
1. Immerse the suction end of the pump into the liquid.
2. Insert the discharge hose into a container to receive the liquid.
3. Turn the switch to the on position to begin pumping. Be careful not to fill the container
too much.
BATTERY CAUTIONS:
1. Non-rechargeable batteries are not to be recharged.
2. All batteries used must be of the same brand and type
3. Do not mix alkaline, standard (carbon-zinc) or rechargeable (nickel-cadmium)
batteries.
4. Do not mix old and new batteries.
5. Remove old batteries.
6. Remove batteries when not in use.
CAUTIONS:
1. Do not run dry. Only switch the pump on after submerging the suction end of the
pump in liquid.
NOTE:
In case any liquid backs up in the hose,it will drain from the bottom
of the "Overow Outlet".Keep hands away from these points.
Do not use this pump near an open ame while pumping gasoline.
2. Do not turn the pump upside down after use.
3. Do not place the pumping container higher than the pump’s batteries housing.
4. Rinse with water after use.
5. Store or use when the unit is thoroughly dry.
ON
OFF
LIQUID
DISCHARGE HOSE
SUCTION END
CAUTION
CAUTION
WARNING