To Next PageTo Next Page
Need help?Do you have a question about the OEM Tools 24533 and is the answer not in the manual?
General| Brand | OEM Tools |
|---|---|
| Model | 24533 |
| Category | Water Pump |
| Language | English |
Contact OEM TOOLS for technical questions and assistance.
Email OEM TOOLS for customer service inquiries.
Check for loose, missing, or damaged parts upon unpacking.
Do not use if broken, bent, cracked, or damaged; remove from service immediately.
Read and follow all safety instructions for safe operation and to prevent serious injury.
Stay alert, use common sense, do not operate when tired or under influence.
Keep work area well-lit, free of obstructions, grease, oil, and debris. Avoid wet locations.
Maintain tools with care, keep dry and clean, do not use damaged tools, use qualified personnel for service.
Wear safety glasses, safety shield, and other appropriate PPE for conditions.
Understand vehicle manual, keep footing and balance, use correct tool, avoid overreaching.
Use only manufacturer-recommended accessories; ensure compatibility.
Ensure proper ventilation, wear snug clothing, keep clear of moving parts to avoid injury.
Handle refrigerants with care; avoid breathing, skin contact, and eye contact to prevent burns and injury.
Do not smoke near engine fuel and battery components to avoid fire or explosion.
Operator must use common sense and caution; manufacturer not liable for unskillful handling.
Venturi-type vacuum pump powered by compressed air for air conditioning service.
Specifies the operational air pressure range for the vacuum pump.
Indicates the optimal air pressure setting for the vacuum pump.
Details the air consumption rate at a specified pressure.
States the vacuum generation capability of the pump.
Provides the recommended maximum continuous operating time.
Dispose of components according to all state, federal, and local regulations.
Lists components with their corresponding figure numbers and quantities.
Illustrates the location and position of key components for reference.
Connect the manifold gauge set to the vacuum pump's tee fitting.
Connect compressed air to the pump inlet and monitor gauge response.
Run the pump for 10-20 minutes after gauge reaches lowest point.
Close valves, disconnect air, let system stand for 5 minutes to check for leaks.
Store in a protected area, away from weather and harmful elements.
Keep the vacuum pump clean for better and safer performance.
One-year warranty; return to place of purchase or OEMTOOLS for repair/replacement.
Excludes products not labeled OEM/OEMTOOLS, abnormal use, abuse, alteration, neglect, or unauthorized repairs.
OEMTOOLS not liable for death, injury, or consequential damages; warranty is in lieu of others.
