8
Operating Instructions and Parts Manual 24815
SANDBLAST BENCH TOP CABINET
5/19
2019 OEMTOOLS™
Problem CAUSE REMEDY
Excessive dust in cabinet. Air vent or airflow is blocked. Abra-
sive media worn.
Too much abrasive medium in the
cabinet.
Loose air line or fitting connections.
Clean rear vent, and keep vent
away from any wall. Replace abra-
sive media
Remove excessive media
Tighten fittings and make sure air
lines are secure
Uneven blasting action. Too much abrasive media inside
cabinet. Abrasive damp.
Moisture present inside cabinet.
Remove excessive media.
Renew abrasive, or dry thoroughly
before use.
Check air line to ensure it is free
from moisture.
Inadequate speed or inefficient
blast.
Abrasive media worn.
Pressure too low.
Replace abrasive media.
Increase inlet pressure and ensure
control valve is fully opened
Static electricity present Dry weather conditions. Leave the item to be cleaned on
the grid
Excessive Media blown into sur-
rounding atmosphere when no
vacuum extraction is being used
Lid not secure
Air vent filter missing
Secure lid with swivel clips, and
adjust them if necessary
Replace filter, or blank off hole in
rear panel temporarily with mask-
ing tape. (Remember to remove
masking tape when using vacuum
extraction.
TROUBLESHOOTING
5/19
2019 OEMTOOLS™
FOR CUSTOMER SERVICE
CALL 1-866-458-2472
www.oem-tools.com
To Previous Page
Loading...
