3
Operating Instructions and Parts Manual 24895 / 24896
9/17
2017 OEMTOOLS
™
18"/24" HEAVY DUTY
WORKSTATION FAN
SPECIFIC SAFETY INSTRUCTIONS
AND WARNINGS
WARNING: Thoroughly read and understand the provided
product manual before attempting to use this product.
WARNING: DO NOT attempt to disassemble, repair or
modify this fan.
WARNING: DO NOT insert your hand or other objects into
the fan guard or near moving parts.
WARNING: DO NOT submerge this fan in liquids.
WARNING: DO NOT touch this fan with wet hands.
WARNING: DO NOT use this fan if the cord or plug has
been damaged.
WARNING: Ensure the wall mount is fastened to a concrete
wall or stud capable of supporting the weight of the fan.
1. DO NOT unplug this fan by holding the cord. Unplug
this fan by holding the plug.
2. DO NOT plug this fan into an extension cord.
3. DO NOT operate near an open flame or heat source.
4. DO NOT use this fan in conjunction with a solid-state
speed control device.
5. DO NOT leave this fan plugged in while unattended.
Always unplug the fan when not in use.
6. DO NOT move or attempt to perform maintenance
while this fan is plugged in.
ASSEMBLY INSTRUCTIONS
CONCRETE WALL INSTALLATION
a) Mark the desired hole location using the Wall Mounting
Bracket, then drill the holes.
b) After drilling, insert the wall anchor and tap until flush
with wall face.
c) Position the Wall Mounting Bracket and screw the 2
bolts into the anchors. Tighten the bolts securely.
WALL STUD INSTALLATION
a) Mark the desired hole location using the Wall Mounting
Bracket, then drill small diameter pilot holes.
b) Position the Wall Mounting Bracket over the pilot holes
and screw the 2 bolts into the stud. Tighten the bolts
securely.
OPERATION INSTRUCTIONS
1. Mount in accordance with provided assembly
instructions.
2. Plug the fan into a grounded 120V / 60 Hz outlet.
3. Adjust to the desired speed by pulling the chain:
24895 24896
0 – OFF 0 – OFF
1 – Low 1 – Low
2 – Medium 2 – High
3 – High
NOTE: To extend the life of the fan motor, allow the fan to
run for at least one minute at each setting before moving to
the next setting.
4. Turn the fan to OFF before unplugging from the
electrical outlet.
STORAGE
Store the Workstation Fan in an upright position and in a
clean, dry area. DO NOT store near flammable items or open
flames.
PRODUCT MAINTENANCE
WARNING: Unplug the fan before performing product
maintenance.
WARNING: DO NOT use water to clean the fan.
Use a vacuum cleaner to remove dust from the protective fan
guard and blades. If desired, remove the front protective fan
guard to access the fan blades. Ensure the protective guard
is securely reattached prior to use.
DISPOSAL
At the end of the useful life of the OEMTOOLS
™
18"/24"
Heavy Duty Workstation Fan, dispose of the components in
accordance with all federal, state and local regulations.
To Next Page
Loading...
