Dean style
SET UP INSTRUCTIONS:
A:Turn on the transmitter.
B:Make sure throttle trim is set to zero.
C:Install batteries (
2 of 7.4v LiPo batteries with Dean style plug).
D:Elevate model so wheels are off the ground.For example:
Use OFNA car stand.
E:Turn the car on using the speed control on/off switch.
F:The transmitter and speed control will go into sync.mode.
This process will take approx. 5 seconds.At this time the
speed control will beep and flash 4 times quickly,then
LED should now stay off.
G:Make sure all controls function properly before use.
Example:Check throttle, brake and steering operation
On car stand.
OFNA BRUSHLESS RTR
SPEED CONTROL
This model is set up to use 2 of 7.4v LiPo batteries.
To Next Page
Loading...
