ESC CALIBRATION
THANK YOU FOR CHOOSING OFNA PRODUCTS.
YOUR HYPER MODEL SHOULD BE CALIBRATED FROM THE
FACTORY.
THE FOLLOW IS THE CALIBRATION PROCEDURE IN CASE ESC
AND RADIO CALIBRATION IS LOST.
IF ASSISTANCE IS NEEDED FEEL FREE TO CONTACT OFNA
TECHNICAL SUPPORT AT 949-586-2910.
STEP 1:
TURN RADIO ON. MAKE SURE THAT THE THROTTLE TRIGGER
AND THROTTLE TRIM ARE IN THE NEUTRAL POSITION.
REFER TO YOU RADIO MANUAL.
STEP 2:
PRESS THE SET BUTTON ON ESC SWITCH AND TURN ESC
ON AT THE SAME TIME. AT THIS TIME THE ESC WILL FLASH
CONSISTATNLY RED AND BEEP.
STEP 3:
WITH THROTTLE TRIGGER IN THE NEUTRAL POSITION
PRESS THE ESC SET BUTTON. NEXT PULL THROTTLE
TRIGGER ALL THE WAY THEN PRESS THE ESC SET BUTTON.
AT THIS TIME THE ESC WILL FLASH GREEN AND
BEEP 2 TIMES.
STEP 4:
PUSH THROTTLE TRIGGER TO FULL BRAKE POSITION
THEN PRESS THE ESC SET BUTTON. AT THIS TIME
THE ESC SHOULD FLASH GREEN AND BEEP A TOTAL OF 7
TIMES. 3 TIMES IS FOR THE COMPLETION OF CALIBRATION
4 TIMES RELATES TO THE BATTERY CELL COUNT USED.
YOUR ESC SHOULD NOW BE CALIBRATED.
To Next Page
Loading...
