Oglo# SB120 - Playback Controls and Call Handling

To Next Page

To Previous Page

To ensure your device is automatically detected the next time it is switched

on, please do not interrupt the pairing procedure.

When the speaker is switched off and switched back on, it automatically tries to

reconnect with the connected source.

USING THE SPEAKER BUTTONS

Your portable speaker can control the audio source connected via Bluetooth* (if it

is AVRCP compatible), using the buttons on top of the device. These buttons are

not enabled when you use the auxiliary input.

• Press the button

briey to pause or resume playback.

• Press the button

to access the next track.

• Press and hold the button

for 3 seconds to access the previous

track.

INCOMING CALL DETECTION

• When a call is received or dialled, the smartphone pauses music playback. The

transmission of music from your phone to the speaker is interrupted.

• When the call ends, the phone resumes playback from the point where it was

interrupted, and plays the music back through the speaker’s loudspeakers.

DISCONNECTING THE SPEAKER

If you wish to disconnect your speaker to pair it to a new audio source, press and

hold the button

for 3seconds. Then begin the pairing procedure again with

the audio source you wish to use.