OHAUS Voyager Balances

Questions and Answers

T
Tina Fernandez MDAug 13, 2025
Why are my OHAUS Scales giving an incorrect weight reading?
- B
  Briana CrawfordAug 13, 2025
  If your OHAUS Scales are showing an incorrect weight reading, it might be because the balance wasn't zeroed before weighing or it's not properly calibrated. Try pressing the O/T button when there's no weight on the pan, and then weigh your item again. If the issue continues, recalibrate the scales correctly.
R
Rachael NunezAug 17, 2025
How to fix OHAUS Voyager Balances that will not turn on?
- P
  Paul MillerAug 17, 2025
  If your OHAUS Scales won't turn on, the power cord may not be plugged in or properly connected. Check all power cord connections to ensure they are secure.
F
fgonzalesAug 21, 2025
Why are my OHAUS Scales readings unstable?
- T
  Timothy EstradaAug 21, 2025
  Unstable readings on your OHAUS Scales can be caused by excessive air current or vibration on the table surface. Check the environmental conditions and place the balance on a stable surface. You may also need to change the averaging level.
A
Aaron CarrollAug 25, 2025
What to do if RS232 interface is not working on OHAUS Voyager Balances Scales?
- A
  awilliamsAug 26, 2025
  If the RS232 interface on your OHAUS Scales isn't working, the print menu settings might not be properly set up, or there could be cable connection issues. Verify that the interface settings in the RS232 menu correspond to those of the peripheral device, and check all cable connections.
A
asanfordAug 28, 2025
How to unlock settings on OHAUS Voyager Balances?
- M
  Mark OdomAug 28, 2025
  If you're unable to change settings on your OHAUS Scales, the lock might be set to ON (LFT set ON). Set the lock switch to OFF to enable changing settings.
M
Meredith WeaverSep 1, 2025
Why can't I change the unit on my OHAUS Scales?
- M
  michaelwrightSep 1, 2025
  If your OHAUS Scales cannot display weight in the desired unit or you cannot access the desired weighing mode, the desired unit may not be selected. Check the settings to ensure the correct unit is chosen.
C
Christian JacobsSep 4, 2025
How to save menu settings on OHAUS Scales?
- Q
  qrodriguezSep 5, 2025
  To store menu settings or changes on your OHAUS Scales, you MUST use SAVE & Exit to leave the menus and save the settings.
B
Bryan RileySep 9, 2025
What to do if OHAUS Voyager Balances display locks up?
- J
  Jason HendersonSep 9, 2025
  If your OHAUS Scales display random segments or the display locks up, the microprocessor might be locked up. Turn the power off, then turn it on again. If the condition persists, the unit must be serviced.