Need help?Do you have a question about the OHAUS Adventurer Pro Balances and is the answer not in the manual?
Overview of the service manual for Adventurer Pro (AV) and Adventurer SL (AS) balances.
Lists special and standard tools for servicing Adventurer Pro/SL balances.
Detailed list of Ohaus special tools and test equipment needed for service.
Presents technical specifications for Adventurer AV and AS model balances.
Provides information for isolating and resolving balance issues.
A table to help locate problem areas by symptom, cause, and remedy.
Step-by-step procedure for diagnosing balance symptoms.
Lists all error codes, their probable causes, and remedies.
Detailed disassembly and replacement procedures for small frame models.
Step-by-step guide on how to safely open the balance for servicing.
Procedure for replacing the strain gauge load cell in small frame models.
Detailed disassembly and replacement procedures for large frame models.
Step-by-step guide on how to safely open large frame balances.
Procedure for replacing strain gauge load cells with InCal feature.
Procedure for replacing the MFR Load Cell.
Procedure for removing and replacing the InCal motor.
Procedure for removing and replacing the InCal mechanism.
Guidelines for performing operational and performance tests.
Steps to perform a basic operational check of the balance.
Performance tests for strain gauge models including repeatability, linearity, etc.
Procedure to check balance repeatability using standard deviation.
Procedure to test balance accuracy when weight is off-center.
Procedure to determine the unit's linearity throughout its operating range.
Performance tests specific to MFR load cells.
Procedure to check MFR load cell repeatability.
Procedure to check MFR load cell accuracy with off-center loads.
Testing the RS232 interface for communication with external devices.
Details on connecting the balance's RS232 interface to a computer.
Procedure for testing the calibration motor (InCal Motor).
Procedure to reset the balance's weighing range with specific weight values.
Procedure to minimize deviation between actual and displayed weights.
Instructions for accessing the balance's service menu.
Detailed steps for performing linearity calibration via the service menu.
Detailed steps for performing span calibration via the service menu.
Instructions for restoring balance EEPROM data using the service tool.
Steps for replacing a load cell using the Adventurer Pro Service Tool.
Guide for updating the balance software using the service tool.
To Next Page
General