What does Err 8.2 mean on OHAUS Scales?
If your OHAUS Scales show 'Err 8.2', it means that either the wrong weighing pan is being used or the pan wasn't installed when the scale was powered on. Make sure you are using the original OHAUS weighing pan and that it is properly installed before turning the scale on.
Why am I unable to calibrate my OHAUS Scales?
If you're unable to calibrate your OHAUS Scales, there are a couple of likely reasons. An unstable environment can interfere with calibration, so try moving the scale to a more stable location. Also, ensure you are using the correct calibration mass. Using an incorrect mass will prevent successful calibration.
How to fix poor accuracy on OHAUS Valor 1000 Scales?
Poor accuracy in OHAUS Scales can stem from a couple of things. It might be due to improper calibration, so try performing a calibration. Alternatively, an unstable environment could be the culprit; in that case, relocate the scale to a more suitable, stable location.
How to fix Err-01 on OHAUS Valor 1000?
The 'Err-01' error on OHAUS Scales indicates invalid under and over limit settings. To fix this, re-enter the under and over limits.
What to do if my OHAUS Scales flashes 'Bat'?
If your OHAUS Scales is flashing 'Bat', it means the battery is discharged. To resolve this, connect the scale to a power source and allow it to charge the battery.
What does '-Over-' mean on OHAUS Valor 1000?
The '-Over-' message on your OHAUS Scales indicates that the weight on the pan exceeds the scale's capacity. Remove some weight from the pan to resolve this.
What to do if my OHAUS Scales display Err 9.5 Err 13?
If your OHAUS Scales display 'Err 9.5 Err 13', there is a system error. Disconnect the power and restart the device.
Why does my OHAUS Valor 1000 display '------'?
If your OHAUS Scales display '------', it indicates that the environment is not stable. Move the scale to a more suitable location.
What does Err 8.1 mean on my OHAUS Valor 1000 Scales?
If your OHAUS Scales display 'Err 8.1', it could be due to using the wrong weighing pan or the load on the pan exceeding the initial weight setting when powering on the scale. Ensure you are using the original OHAUS weighing pan and remove any load from the pan before turning the scale on.
Why does my OHAUS Valor 1000 Scales show CAL E?
If the OHAUS Scales display 'CAL E', it means the environment might not be stable, or the calibration masses being used are incorrect, or there is a system error. Try moving the scale to a more stable location and calibrate it again. Ensure you are using the correct calibration masses as shown on the screen during the calibration. If the error continues, it could be a system error.
Details safety warnings, symbols, and precautions for operation.
Identifies and explains the function of the scale's buttons and interface.
Procedure for performing the first-time calibration to ensure accurate weighing results.
Instructions on how to perform accurate weight measurements using the scale.
Procedures for calibrating the scale, including span and linearity adjustments.
Common error codes, causes, and solutions for scale operational issues.
Detailed technical specifications, models, capacities, and dimensions.
General| Housing | ABS Plastic |
|---|---|
| Platform Size | 190 x 242 mm |
| Display | LCD with backlight |
| Power | AC Adapter or Rechargeable Battery |
| Operating Temperature | -10°C to 40°C |
| Calibration | External calibration |
| Units of Measurement | g, oz |
| Interface | RS232 |
| Readability | 0.5 g - 10 g (depending on model) |
To Next Page
