67
SEW 7050
EN
PRELIMINARY OPERATIONS
5. Hold the upper thread between the ngers of your left hand, then turn the handwheel
(6) to move the needle up and down (Fig. F25).
6. The upper thread raises the coil thread (Fig. F26).
7. Pass the two threads under the foot, then push the lever (8) down to lower the foot.
8. Replace the transparent cover (36) (Fig. F27).
USE
☞
• Scrupulously follow all the sewing steps.
• The stitch selection knob (17) does not rotate when the
appliance is operating.
• Before adjusting the stitch selection knob (17), make sure you
have correctly raised the needle (10) by turning the handwheel
(6) counterclockwise.
• The appliance is not suitable for sewing stretch fabrics, towels,
etc.
•
Place the appliance on a horizontal, at, clean, dry and stable surface
.
> > Sewing forward
1. Turn the handwheel (6) counterclockwise to raise the needle (10) to the highest po-
sition (Fig. F7).
2. Raise the foot (13) by pressing the foot lifting lever (8) upwards, gently pull the coil
thread and the upper thread towards the back of the appliance for about 10 cm (Fig.
F28).
3. Position the fabric under the foot (13) and press the foot lifting lever (8) downwards
(Fig. F29).
4. Turn the knob (17) and select the desired stitch.
5. Turn the handwheel (6) several times counterclockwise to make sure there are no
jams at the stitches.
6. Switch on the appliance by moving the selector (7) to “L” (minimum speed) or “H“
(maximum speed); the appliance starts (Fig. F30).
To Next Page
Loading...