69
SEW 7050
EN
> > Buttonhole sewing
1. Turn the handwheel (6) counterclockwise to raise the needle (10) to the highest po-
sition.
Raise the foot (13) by pressing the foot lifting lever (8) upwards.
Place the fabric under the foot (13) and press the lever (8) down to lower the foot.
2. Turn the knob (17) and select the stitch on “8”.
3. Move the selector (18) to “L” (minimum speed) and sew about 5/6 stitches (Fig. F31).
Then move the selector (18) to “OFF” (appliance o).
4. Turn the knob (17) and select the stitch on “7”.
5. Move the selector (18) to “L” (minimum speed) and sew until reaching the desired
length; pay attention to make a straight seam
(Fig. F32).
Then move the selector (18) to “OFF” (appliance o).
6. Turn the knob (17) and select the stitch on “8”.
7. Move the selector (18) to “L” (minimum speed) and sew about 5/6 stitches (Fig. F33).
Then move the selector (18) to “OFF” (appliance o).
8. Raise the foot (13) by pressing the foot lifting lever (8) upwards.
Rotate the fabric 180° to sew the last part of the buttonhole, then lower the foot by
pressing the lever (8) downwards.
9. Turn the knob (17) and select the stitch on “7”.
10. Move the selector (18) to “L” (minimum speed) and sew until the buttonhole is
closed; pay attention to make a straight seam (Fig. F34).
Then move the selector (18) to “OFF” (appliance o).
11 After nishing the seam, turn the handwheel (6) counterclockwise to raise the nee-
dle (10) to the highest position.
Raise the foot (13) by pressing the foot lifting lever (8) upwards, then remove the
fabric and cut the thread with the appropriate thread cutter (11).
USE
To Next Page
Loading...