Need help?Do you have a question about the OJ Electronics OJ-DV-3030 and is the answer not in the manual?
General| Enclosure class | IP20 |
|---|---|
| Protection Class | Class II |
| Output | Relay |
| Operating Temperature | 0°C to 40°C |
| Storage Temperature | -20°C to 60°C |
| Relative Humidity | 5% to 95% (non-condensing) |
| Weight | 0.15 kg |
| Supply voltage | 230 V AC ±10%, 50/60 Hz |
| Maximum load | 16 A / 3600 W @ 230 V~ |
Only trained/qualified personnel should install the product.
Qualified personnel must know installation practices and regulations.
Personnel must follow manual instructions and safety precautions.
OJ-DV contains dangerous high voltage when connected to mains.
Always disconnect mains voltage before installation or service.
Risk of motor starting unintentionally, posing a danger.
Unintentional start during programming or service may cause injury.
Fit all components before connecting mains voltage.
Close all covers and glands before connecting mains voltage.
Capacitors remain charged after power off; risk of injury if touched.
Incorrect installation can cause overheating and performance impairment.
Installation must be performed by trained/experienced personnel.
Proper cooling needs airflow over fins; reduced power if airflow is poor.
Installation by trained personnel; check rating plates; hazards exist.
Risk of induced voltage on motor terminals from natural fan rotation.
Installer must provide compliant short-circuit protection.
Risk of DC current; use Type B RCDs for extra personal protection.
Follow regulations for grounding with leakage current exceeding 3.5 mA.
Connect motor cable to U,V,W,PE; use shielded cable and proper shield termination.
Connect power cable to supply terminals; observe grounding and PE wire length.
Check attachment, airflow, cover mounting, and unused openings.
Check cable insertion, tightening, voltage supply, and condition.
Check wiring, voltage, and short-circuit protection.
Check motor cable connection and terminal tightening torque.
Verify short-circuit protection is correctly fitted, sized, and safety equipment is operative.
Check earthing is correct, free of oxidation, and has proper continuity.
Limits output current to protect motor and cables.
OJ-DV motor output terminals are short-circuit protected.
Keep cooling fins clean for proper cooling and performance.
OJ-DV cannot be repaired on site; contact supplier for replacement.
Disconnect power for 3 minutes before opening due to residual currents.
Risk of induced voltage on terminals if fan rotates without operating signal.
Table of symptoms, causes, and actions for A/D signal control.
Table of symptoms, causes, and actions for Modbus control.
Details fuse, impulse, over-voltage, overload, and short-circuit protection.
To Next Page
