Error Codes
If a malfunction occurs, an error code will be appear on the display. Please refer
to this chart for description of error code.
Error Code Meaning Solution
01 Normal
03 Brake applied Resume brake position
04 Throttle is not at start position Reposition the throttle
05 Throttle problem Change throttle
06 Low voltage protection Charge immediately
07 Overvoltage protection Check battery voltage
08 Motor hall signal line Check motor wire or
malfunction change motor
09 Motor phase wire malfunction Check motor wire or
change motor
10 Controller overheated and has Take a break to cool the
reached its protect limit controller before riding
11 Controller temperature sensor Change controller
malfunction
12 Controller current sensor Change controller
malfunction
21 Speed sensor malfunction Check if the motor can
output the speed signal
23 Head light malfunction Change controller
30 Communication malfunction Check wires or change
dash board
Horn
The yellow horn button on the OjO can be found on the left side of the handlebars.
Key Fob
Included with the OjO is a key fob (see below) that
is necessary for riding, as well as for theft deterrence.
(2 Key Fobs included)
A. Press ON/OFF button once to turn OjO on.
B. Press ON/OFF button once to turn OjO off..
C. Press (lock button) once to arm alarm.
D. Press (unlock button) once to disarm alarm.
A.
B.
C.
D.
Replacing Key Fob Battery
Remove case back using a small coin or equivalent. Using small screw driver or
similar device, push battery from battery edge so that it slides out from beneath
the battery hold down bracket. DO NOT ATTEMPT TO REMOVE THE BATTERY
HOLD-DOWN BRACKET. Slide in new battery (CR 1632). Snap Key fob case
back together.
Kickstand
Make sure kickstand is in the up position prior to riding the OjO. Do not sit on
your OjO with the kickstand in the down position. Make sure the OjO is stable
before stepping off.
Lights
Your OjO is equipped with state of the art front and rear LED lights.
The headlight and taillight is controlled by the light icon on the display.
The brake light illuminates when the brakes are applied whether lights
are on or off.
Cleaning OjO
A quality automotive soap works best in removing dirt and grime. Avoid
brushes and abrasive scrub pads as they may scratch the finish. Use a soft
sponge or hand towel to wash the body panels. AVOID using high
pressure washers as they may damage wiring harnesses. A battery
pack should NEVER be pressure washed. If you live close to an ocean,
avoid prolonged exposure to ocean spray or salt water. If either comes in
contact with your OjO, wipe down immediately.
Motor
The Patented 500kw HyperGear Motor is completely sealed and requires
no maintenance or lubrication. Keep free of sand and other debris.
Do not ride or submerge in standing water.
Seat
Your OjO seat height is adjustable. Ensure that both feet can easily touch
the ground when setting height. Important: Make sure seat height is set
and the seat clamp is tight before riding the OjO. The OjO scooter is
designed for a single rider only.
18 19
www.ojoscooter.com www.ojoscooter.com
To Next Page
Loading...