CLEANING & CARE
Fig.
12
Switch the product into Standby and unplug in order to disconnect from the mains.
Note:
Clean the product every two weeks. Clean the outer surfaces of the product with a damp
cloth soaked in neutral detergent. Dry it with a lint-free cloth. Do not use chemical, alkaline,
abrasive or other aggressive detergents as they might be harmful to the surfaces.
Fig.
13
Remove the air lters. Clean the air lters in warm water (below 40 °C) and neutral detergent.
Fig.
14
Let them dry thoroughly before re-attaching.
• Do not open the housing of the product and do not insert any tools into the air vents.
• This product does not contain any parts that can be repaired or serviced by the consumer.
Contact a qualied specialist to have it checked and repaired as necessary.
DECOMMISSIONING
1. Drain all water from the product and dry it using the fan mode
for half a day in a dry, warm room
to prevent mould.
2. Switch the product into standby.
3. Unplug and x the power cord with the cable tie on the back of the product.
4. Remove the exhaust hose assembly from the product.
5. Cover all drain outlets.
6. Remove the batteries from the remote control.
7. Close the cover of the wall adaptor.
Fig.
15
TRANSPORTATION
• The product is heavy. Therefore move the product whenever possible by pushing or
pulling it, rolling on the castors.
• When lifting is unavoidable, use the recessed handles and lift with two people.
• Do not move the product during operation.
• Wait at least 2 hours after moving before operating the product to avoid damages on the
refrigerating circuit.
IM_OAC2221_161201_V04_HR.indb 28 1/12/16 4:31 PM
To Next Page
Loading...