OK. OCR 160PR - Alarm setting; ALARM 1; ALARM 2; Stop alarm

23
EN
Alarm setting
The alarm can be set only if the FM radio is in o mode (Standby):
3
ALARM 1
1. Press the AL1/VOL- button for apprx. 2 seconds and the
alarm time will be ashing on the display.
Note: If no settings done within 5 seconds the display
will turn o into standby.
2. Set the hours with HOUR button and minutes with MIN
button.
3. Conrm the time with AL1/VOL-.
4. To select one of the below alarm functions, press and
hold the button AL1/VOL- until the alarm time is
ashing on the display. Press the AL1/VOL- button again
to select one function.
Below alarm functions are available:
Press AL1/VOL- On display
1 x Alarm time 1 +
2 x Alarm 1 +
3 x Alarm function de-activated
ALARM 2
1. Press the AL 2/VOL+ button and the alarm time 2 will be
ashing on the display.
2. For setup, switching on/o of ALARM 2 follow the instruc-
tions as given for setup of ALARM 1. But instead of push-
ing AL1/VOL- button push AL 2/VOL+ button.
Stop alarm
1. Snooze function: Press SNOOZE button to suspend alarm
sound for a few minutes. The alarm will start again after
approx. 9 minutes. The set alarm mode will remain ashing on
the display.
2. Press FM/OFF to stop/cancel alarm.
IM_OCR160PR_170810_V04_HR.indb 23 10/8/17 2:58 pm