Operating Your Printer 2 – 9
Loading single sheets
Your printer can accomodate single sheets of 216 by 297 or 355mm (8.5
by 11-inch or 14-inch) paper. Only one copy, with no carbons, can be
printed at a time.
Remove the tractor feed unit and any other accessories before using the
paper separator.
Operation
1. Place the paper release lever in its closed (rear) position.
2. Switch the printer OFF-LINE (press the SELECT switch).
3. Close the paper bail lever (To its rearward position).
4. Raise the paper separator as shown in the figure below.
5. Adjust the cut sheet guide on the paper separator to position the left
edge of the paper sheet.
Paper separator
Single sheet
Stay
Paper bail
lever
Cut sheet
guide
To Next Page
Loading...
