3 – 2 Programming
Skip Over Perforation: If you use fanfold paper with your printer,
you may need to use this command to
instruct the printer to automatically
advance the paper over the perforations.
Character Pitch: You can change from 10 to 12 or 17.1
characters per inch and you can also double
the character width (10 characters per inch
to 5 characters per inch, 12 characters per
inch to 6 characters per inch and 17.1
characters per inch to 8.5 characters per
inch).
Enhanced/Emphasized: Prints characters in a bolder type,
commonly used for titles and subtitles.
Underlining: Underlines a word or group of words.
Character Sets: Choose from two different character sets;
IBM character set one or two is selectable.
There is also a switch selection which
enables you to power up the printer in
either set and to establish the default
character set.
APA Graphics: Enables you to draw graphs, charts, and
pictures.
Cancel: Clears the data in the print buffer.
What you do next depends on whether you have invested in a software
package. If you have, skip to page 3-17 for advice on how to add these
features to your prepackaged software. If you do not have a software
package, continue reading.
To Next Page
Loading...
