6.5 -C Option (lpr Command) 37
Selecting a Paper Output Tray
The following parameters can be specified:
Selecting a Paper Type
The following parameters can be specified:
Specifying 2 sided Printing
The following parameters can be specified:
Note
• If several parameters are specified in one “lpr” command, data may not be printed correctly.
• The system default is used if no parameter is specified.
• If the print data specifies 2 sided or 1 sided printing, the specification by the data becomes valid and
overrides that by -C option.
Parameter Description
OUTUP/outup Ejects prints to the rear tray (option).
OUTDOWN/outdown Ejects prints to the center tray.
Parameter Description
PTS/pts Selects Plain paper.
PT1/pt1 Selects Heavy weight paper 1.
PT2/pt2 Selects Heavy weight paper 2.
POH/poh Selects Transparency.
PRC/prc Selects Recycled paper.
Parameter Description
DUP/dup 2 sided printing as follows:
TUMBLE/tumble 2 sided printing as follows:
SIMP/simp 1 sided printing
To Next Page
Loading...
Need help?
General
