C610/C711 Memory Installation > 5
11. Gently push the board into the RAM expansion slot until it latches
in and will not go any further.
12. Locate the retaining clips at the bottom of the side cover into their
rectangular holes near the bottom of the printer.
13. Close the top of the side cover up to the printer and refit the
securing screw loosened in step 4.
14. Close the front cover, and close the top cover, pressing down
firmly at each side to latch it closed.
15. Reconnect the AC power cable and switch the printer on.
16. When the printer is ready, print a menu map as follows:
(a) Press the Enter button.
(b) Press the Menu down button then the Enter button to
select the Print Information menu.
(c) Select Configuration with the Enter button.
(d) Press the Enter button once more to execute the
Configuration menu.
To Next Page
Loading...
